What is the installation method of belt conveyor rain cover

How to install the belt conveyor rain cover?

1. When installing, press the open-close cover on the adjacent fixed covers on the left and right, and their overlapping length is one wave pitch or two wave pitches. Pay attention to place the hinged side of the open-close cover on the non-passage side of the conveyor, and place the lock side on the pass-through side of the conveyor.

2. The frame of the fixed conveyor rain cover is connecting angle steel or Z-shaped steel, and its length is equal to the installation length of the conveyor cover. Weld the connecting angle steel or Z-shaped steel to the channel steel or small angle steel on both sides of the conveyor frame. If you need to install the support angle steel, first weld the support angle steel to both sides of the frame, and then weld the connecting angle steel or Z-shaped steel to the support angle steel.

3. Install the rain cover in a vertical pattern from one end of the rack to the other. It is strictly forbidden to stand on the rain cover during installation, and do not hit or knock it hard.

4. Use self-tapping nails to fix the rain cover on the connecting angle steel or Z-shaped steel, with no less than 4 fixing points on each piece.

5. An observation rainproof cover can also be installed every ten pieces to facilitate maintenance and inspection.

https://www.songdaglobal.com/