Stacker Classification

Jan 03, 2024

Elevated bridge belt stacker
As shown in Figure 1, the elevated bridge type belt stacker is installed on a movable bridge that spans the material pile. There is an S-shaped unloading cart on its stacking belt conveyor, which moves in the opposite direction to the bridge, allowing the stacking function to stack materials at any point in the pile. This type of stacker is suitable for material piles with trapezoidal cross-sections, and can also be used for wave shaped or horizontally layered material piles.
Rake stacker
As shown in Figure 2, the rake stacker, also known as the chain rake, is a device that can both stack and retrieve materials, mainly used for side stacking. Some chain rakes can also be reversed, that is, the direction of rotation during stacking is opposite to that during material retrieval, and the material is sent down the chain through the opening in the rake rod. The rake type stacker greatly improves the stacking capacity through the joint operation of the stacking belt and scraper installed in the chain scraper.
Overbridge belt stacker for top stacking
As shown in Figure 3, the overhead conveyor belt stacker for top stacking is used in the case of a pre homogenization stacking plant located inside the factory building. The main feeding conveyor of the yard is connected to the roof truss through the roof of the factory building, and is connected to the overhead conveyor on the roof truss. The equipment used in this stacker is relatively simple. As long as an S-shaped belt discharge truck is installed on the overpass belt conveyor, the material can be stacked directly from the overpass belt. However, it can only be used as a herringbone or conical material. If wave shaped stacking is used, it will make the structure of the stacking equipment complex. Another disadvantage of it is the large material drop. Therefore, this type of equipment is less commonly used in cement plants.
Rotary cantilever belt stacker
As shown in Figure 4, the rotary cantilever belt stacker is the most widely used side stacker in the pre homogenization yard. It mainly consists of two parts: one is the S-shaped belt discharge cart connected to the main feeding belt conveyor in the yard, which functions to deliver materials to the stacking belt conveyor through the S-shaped turning point of the feeding belt; The second is the cantilever stacking belt conveyor that extends horizontally above the material pile. The cantilever belt stacker can be fixed or a rotary cantilever belt stacker that rotates around the central axis. Its rotational motion is driven by an electric motor and can rotate 360 degrees.

You Might Also Like