What is the design of driving wheels for belt conveyors

There are many reasons for deviations, and they need to be dealt with according to different reasons. High-angle conveyor belts consist of base belts, edge guards and partitions. Edge protection is used to prevent material slipping and scattering. In order to bypass the roller, the edge of the baffle is designed to be corrugated; the baffle is used to support the material, and in order to achieve large-angle conveying, a T-type TC type is used. The separator and diaphragm are connected to the baseband using secondary vulcanization, and the connection strength is high.

1. Adjust the position of the roller group to adjust the deviation of the belt conveyor where the roller group is located when the conveyor belt deviates in the middle of all belt conveyors; during manufacturing, perform long hole processing on the equipment holes on both sides of the roller group Adjustment. The specific method is to move the belt to which side, the roller group on which side moves forward to the direction of the belt, or the other side of the belt conveyor moves backward. If the belt deviates upward, the lower position of the roller group moves to the left, and the upper position of the roller group moves to the right.

2. There are many types of centering idling, such as rotating shaft type, four type, crushing roller type, etc. The principle is to use blocking or roller rotation to generate lateral thrust in the horizontal direction, making the belt active to achieve the purpose of adjusting the belt deviation. It is reasonable to adopt this method when the total length of the belt conveyor is short or the belt conveyor runs in both directions, because shorter belt conveyors are more likely to deviate and difficult to adjust. Do not use this method for long belt conveyors, because the use of centering roller sets will have a certain impact on the service life of the belt.

3. Adjust the position of the driving roller and the direction change roller is an important part of the belt deviation adjustment. High-angle conveyor belts consist of base belts, edge guards and partitions. Edge protection is used to prevent material slipping and scattering. In order to bypass the roller, the edge of the baffle is designed to be corrugated; the baffle is used to support the material, and in order to achieve large-angle conveying, a T-type TC type is used. The separator and diaphragm are connected to the baseband using secondary vulcanization, and the connection strength is high. Since the belt conveyor has at least 2 to 5 rollers, the installation position of all rollers must be perpendicular to the center line of the length direction of the belt conveyor. If the deviation is too large, there will be deviation. The adjustment method is similar to adjusting the roller set. For the head drum, if the belt runs to the right side of the drum, the bearing seat on the right side needs to move forward. If the belt runs to the left side of the drum, the bearing seat on the left side needs to move forward. Of course, the bearing seat on the left can also move backward, and the bearing seat on the right can also move backward. The adjustment method of the tail roller is completely opposite to that of the head roller. Adjustment method. Repeat the adjustment until the strap is in a more relaxed position. Install the rollers in the correct position before adjusting drive or changing direction.

https://www.songdaglobal.com/