Installation and maintenance of mining crushers
Jan 17, 2024
preface
The maintenance and upkeep of a machine is an extremely important and routine task, which should be closely coordinated with the operation and maintenance of the machine, and there should be dedicated personnel on duty for inspection
Maintenance of the machine
1. Bearings bear all the load of the machine, so good lubrication has a great relationship with the bearing life, which directly affects the service life and operating rate of the machine. Therefore, it is required that the injected lubricating oil must be clean and the seal must be good. The main oil injection point of this machine is ⑴ the rotating bearing ⑵ the rolling roller bearing ⑶ all gears ⑵ the movable bearing and sliding plane
Newly installed wheels are prone to loosening and must be checked regularly
3. Pay attention to whether all parts of the machine are working properly
4. Pay attention to checking the degree of wear on easily worn parts and replace worn parts at any time
5. The bottom frame plane of the movable device should be cleaned of dust and other objects to prevent the movable bearings from moving on the frame when the machine encounters unbreakable materials, which may lead to serious accidents
If the bearing oil temperature rises, it should be stopped immediately to check and eliminate the cause
7. If there is any impact sound during the operation of the rotating gear, it should be stopped immediately for inspection and eliminated
Installation and commissioning
1. The equipment should be installed on a horizontal concrete foundation and fixed with anchor bolts.
During installation, attention should be paid to the verticality of the main body and the horizontal.
3. After installation, check whether the bolts in each part are loose and whether the main engine compartment door is fastened. If so, please tighten it.
4. Configure the power cord and control switch according to the device's power configuration.
5. After the inspection is completed, conduct a no-load test run. If the test run is normal, production can proceed.
